Badger
|
wheel bearingsTrying to figure out the vib an nosies from the front axles well pinon bearing loose so i tightened it the checked wheel bearings to find out both are fawked 198$ apiece TRW got one today have to order the other monday.
|
89lxstanger
|
that sucks man
|
lostsoul
|
DAMN I know I did enough of them on the XJ.
|
allan3306
|
Those one piece hubs are a pain because you can't clean and repack them.
|
Badger
|
replace once then go bigger
|
allan3306
|
Now your talking!!!!
|
scrappy
|
ya couldn't get one matched up from Canada bearing i would think they'd be cheaper
|
lostsoul
|
It is a complete hub Scoob, I do not think they can be taken apart to just replace the bearing!
|
allan3306
|
They can come appart but it's not worth the time and effort and you could crack a race pressing in back together. Then you have to save the old seal without damaging it (good luck) so in other words buy the assembly bolt it in and go. But then again that would be to easy for Scooby he would have to make it complicated and spend more money than is needed.
|
scrappy
|
Re: wheel bearings | Badger wrote: | | Trying to figure out the vib an nosies from the front axles well pinon bearing loose so i tightened it the checked wheel bearings to find out both are fawked 198$ apiece TRW got one today have to order the other monday. |
i thought he was talking about the pinon bearings as for the hubs bearings if there the same as my heep i can get them for $65
|
Badger
|
Re: wheel bearings | scrappy wrote: | | Badger wrote: | | Trying to figure out the vib an nosies from the front axles well pinon bearing loose so i tightened it the checked wheel bearings to find out both are fawked 198$ apiece TRW got one today have to order the other monday. |
i thought he was talking about the pinon bearings as for the hubs bearings if there the same as my heep i can get them for $65 |
Ya i could have got the jobber one's for 60$ apiece but don't feel like changing them every month.
|
scrappy
|
there good for about a year
|
lostsoul
|
I agree with the cheap ones, I had one on the white one, lasted two weeks an off it went.
|
Badger
|
Got my new hub bearings installed this morning no noise no vib 
|
lostsoul
|
WOO HOO so we should expect you for the Chipawa run tomorrow?
|
Badger
|
Would love to but need to notch cross member for front shaft clearence and make up new skid plate an few other thing's boss gone can't get into shop to work on it.
got lot's of clearence for tire's though.
|
|
|
